Dimmers
Dimmers
Dimmers
Products
GRMS » Wired GRMS Range » Dimmers »
Dimming actuator 6-channels
Product Number: DIM-ACTR-6-CH
- DA3-66M is a universal dimming 6-channels actuator, which is used to control the brightness of dimmable light sources such as ESL, LED and RLC with 230 V power supply.
- The DA3-66M has 6 semiconductor controlled 230 V AC outputs. The maximum possible load is 150 VA for each channel.
- The individual outputs of the dimmer can be connected in parallel and thus increase the maximum output load at the expense of the number of outputs.
- Each output channel is independently controllable and addressable.
- The type of light source is set with a switch on the front of the device.
- By setting the min, the brightness potentiometer on the front of the device eliminates flickering of different types of light sources.
Order Inquiry
Description
- DA3-66M is a universal dimming 6-channels actuator, which is used to control the brightness of dimmable light sources such as ESL, LED and RLC with 230 V power supply.
- The DA3-66M has 6 semiconductor controlled 230 V AC outputs. The maximum possible load is 150 VA for each channel.
- The individual outputs of the dimmer can be connected in parallel and thus increase the maximum output load at the expense of the number of outputs.
- Each output channel is independently controllable and addressable.
- The type of light source is set with a switch on the front of the device.
- By setting the min, the brightness potentiometer on the front of the device eliminates flickering of different types of light sources.
- Min. brightness and type of load is performed using SW IDM.
- Use the control buttons on the front panel to manually control the output.
- The actuator is equipped with electronic overcurrent and thermal protection, which switches off the output in case of overload, short circuit, overheating.
- During installation, it is necessary to leave at least half of the module space free on each side of the actuator for better cooling.
- DA3-66M is in 6-MODULE version and is intended for mounting in a switchboard on DIN rail EN60715.
- The dimmer has 6 galvanically separated inputs which can be used both to control the dimmer and as a binary input to the Dynamicpro system.
- The the device supply (potential L) must be protected with a safety device corresponding to the power input of the connected load, e.g. with a quickrelease fuse.
Specification
- Output: R – L – C – LED – ESL; 150 VA (230 V) / 75 VA (120 V)
- Input: 6x wire buttons
- Supply voltage (frequency): 230 V AC (50 Hz); 120 V AC (60 Hz)
- Rated current from BUS: 100 mA (at 27 V DC)
- Housing: 6-MODULE
- Dimensions: 90 x 105 x 65 mm
Downloads
Contact Us
- Address:
CANADA: Unit 157 – 99 Scurfield Boulevard, Winnipeg, MB, R3Y 1Y1 , CANADA.
UAE: LIU No.11 Dubai Silicon Oasis P.O. Box 293640 Dubai United Arab Emirates - Email us:
info@dynamicpro.ca
info@ateis.ae - Call:
Canada Office: +1 (204) 306 5173
UAE Office: +971 (4) 3262730
